The PowerTector #Battery Guard is a solid state device that will monitor the source voltage and disconnect the equipment from the battery if the voltage falls below a pre-determined level. This can work to ensure that there is always sufficient voltage remaining in the battery to start a vehicle engine or ensure power is available for other critical applications.

There are six units in the range offering power options from 10A to 200A. All units are rated IP65 and come complete with up to 10 pre-programmed configurations to suit all likely battery protection requirements. The PT40 (40A) and PT60 (60A) units offer additional information inputs and outputs including on/off terminal, warning light/buzzer and programming. The PT100 (100A) and PT200 (200A) units offer in addition a manual override switch to re-connect short term power if required.

Battery Protector

If you need to power 6 volt equipment in a 24 volt vehicle install an #Alfatronix voltage dropper. Available in 36, 50 and 90 watt models.

If you need to stabilise your voltage or isolate your supply install DDi Series of 12V-12V and 24V-24V Isolators.